Technology Magazine Products About HORECA Contact us

Magazine · Water science

Micro- and nano-plastics in drinking water

A 2024 study counted 240,000 plastic particles per litre of bottled water — roughly 90% of them nanoplastics. Exposure is no longer occasional. It is continuous.

Reading time 4 minReviewed November 2026By DeepTech Limited
Microplastics in drinking water

The scale of exposure

A 2024 study published in PNAS by researchers at Columbia and Rutgers found an average of 240,000 plastic particles per litre in bottled water, with roughly 90% of them in the nanoplastic range — small enough to be invisible under a standard microscope.

Illustration of a human figure half formed from plastic waste
Microplastics were detected in every human subject tested in 2024. Illustration: AGUAFLUX.

Also in 2024, researchers detected microplastics in 100% of the human subjects tested. Particulate matter was found in the liver, the brain and other organs. The finding matters less for any single particle than for what it implies: the exposure is not an occasional event, it is a permanent condition of modern water supply.

Why particle size decides the risk

Whether a particle is a nuisance or a hazard depends almost entirely on its size.

>150 µmToo large to cross the gut barrier — it leaves the body.
<20 µmCan cross the gut barrier and end up in human organs.
~90%Of particles in bottled water are nanoplastics — the smallest fraction.

The long-term consequences of this exposure have not yet been confirmed at scale, but both the tendencies and the risks are clear. That is the uncomfortable position: the evidence is incomplete, while the exposure is not.

Glass is not the answer

Glass bottles do not release chemicals the way plastic can, which is why water in glass tastes different. But a 2025 study by the French food-safety agency ANSES found the highest average microplastic concentration in glass-bottled drinks — not in plastic ones or cans.

The finding is about packaging adding particles, not about glass being unsafe to drink from.

“The drinks in glass bottles are often 5 to 50 times higher than in plastic bottles or cans.”
Microplastic particles seen under magnification beside a glass bottle
The particles concentrate at the closure, not in the glass itself. Image: AGUAFLUX.

The mechanism is the closure, not the bottle. “Metal” caps shed nanoplastics during manufacturing and transport, and release a further 100,000 particles when the bottle is opened. Glass solves the packaging question and leaves the particle question untouched.

What a filter can and cannot hold back

Filtration is the only route that removes particles without adding a new container to the problem. An in-line multistage system sits between the supply and the tap, so the water never enters packaging at all.

The AGUAFLUX position

AGUAFLUX systems produce premium-tasting mineral water with zero micro- and nano-plastics: none pass through the filtration train, and none are added by the filters themselves.

That distinction matters more than it sounds. A filter that removes particles but sheds media of its own has not solved anything — which is why cartridge specification is set from a source-water panel rather than from a catalogue.

References

  1. Qian, N. et al. (2024). Rapid single-particle chemical imaging of nanoplastics by SRS microscopy. PNAS 121(3), e2300582121. doi.org/10.1073/pnas.2300582121 — source of the 240,000 particles per litre figure, ~90% of them nanoplastics.
  2. Columbia University Mailman School of Public Health (9 Jan 2024). Bottled water can contain hundreds of thousands of nanoplastics.
  3. ANSES, French Agency for Food, Environmental and Occupational Health & Safety (20 Jun 2025). The caps of glass bottles contaminate beverages with microplastics — published in the Journal of Food Composition and Analysis.
  4. The Independent (23 Jun 2025). Up to 50 times more microplastics in glass-bottle drinks than plastic ones — the “5 to 50 times” comparison.

Water without the particles

Send us your source-water analysis, or the address and a description of the site, and our engineers come back with the stage order and cartridge grade that fit the water you actually have.

Request a proposal

Leave your details and our distributor will reply within one business day.

By sending this form you agree to our Privacy Policy. We use these details only to answer your enquiry.